TomTom GO 730

From OpenTom

Jump to: navigation, search

Btconsole works (tested with 1.02_en)

Bootscreen (handcopied):

TomTom GO(TM) (c) TomTom 2003-2008 Build -N/A-
Hardware type:                      TomTom Go 730
SubID (feature) 0 1:                0004 (000000000...00000)
Bootloader version:                 S5.5120 clist#281356 RVCT
Checksum:                           643D
Memory:                             64 MB
CPU ID:                             32443001
Clocks:                             396.000 132.000 66.000
GPS type:                           SIRF 3 FFFF
TFT Type:                           Samsung LTE430WQ 6
SD Card capacity:                   .. kByte
Internal FLASH capacity:            2007040 kByte
MMC NAND version (PRV):             0036 33000000 Hz 8 bits(Samsung)
Startup mode:                       Reboot
Device ID:                          J41299F00664
Bluetooth MAC address:              00:21:3E:D2:xx:xx
Bluetooth calibration:              0x0024
Touchscreen calib. data:            82 931 124 845 @3300mV
Sector protection:                  Yes
Batter boot voltage:                5000 mV
RTC:


# cat /proc/cpuinfo
Processor       : ARM920Tid(wb) rev 0 (v4l)
BogoMIPS        : 197.83
Features        : swp half thumb
CPU implementer : 0x41
CPU architecture: 4T
CPU variant     : 0x1
CPU part        : 0x920
CPU revision    : 0
Cache type      : write-back
Cache clean     : cp15 c7 ops
Cache lockdown  : format A
Cache format    : Harvard
I size          : 16384
I assoc         : 64
I line length   : 32
I sets          : 8
D size          : 16384
D assoc         : 64
D line length   : 32
D sets          : 8

Hardware        : TomTom GO
Revision        : 4000a
Serial          : 0000000000000000
# free
              total         used         free       shared      buffers
  Mem:        61924        60344         1580            0          144
 Swap:            0            0            0
Total:        61924        60344         1580
# dmesg
ing delay loop... 197.83 BogoMIPS (lpj=494592)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
unpacking initramfs... done
Freeing initrd memory: 7168K
NET: Registered protocol family 16
S3C Power Management, (c) 2004 Simtec Electronics
S3C2443: IRQ Supportg architecture
S3C2443: Clock Support, EPLL 72.000 MHz
S3C24xx CpuFrequency Scaling (DVS), (c) 2008 TomTom B.V.
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
Bluetooth: Core ver 2.7
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
S3C DMA Driver, (c) 2003-2004 Simtec Electronics
DMA channel 0 at c4800000, irq 88
DMA channel 1 at c4800100, irq 89
DMA channel 2 at c4800200, irq 90
DMA channel 3 at c4800300, irq 91
DMA channel 4 at c4800400, irq 92
DMA channel 5 at c4800500, irq 93
ngffs: init_ngffs_fs: NGFFS initializing
TomTom GO Backlight S3C, (C) 2007 TomTom BV
Activate backlight_en
TomTom GO Framebuffer Driver, (C) 2005 TomTom BV
ttgfb: ttgfb_alloc: Using LFB from bootloader (reserved memory).
S3C2410 RTC, (c) 2004 Simtec Electronics
s3c2410-rtc s3c2410-rtc: rtc disabled, re-enabling
S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics
S3C24XX Internal Flash poweroff workaround, (c) 2008 TomTom
----------------------si4710_i2c_probe------------------- DONE
LTC3455 Power Management IC I2C driver v1.0 (C) 2008 TomTom B.V.
TomTom GO Hardware Detection Driver, (C) 2004,2005 TomTom BV
TomTom GO ADC Driver, (C) 2004-2007 TomTom BV
TomTom GO S3C24XX Generic ADC Driver, (C) 2007 TomTom BV
TomTom GO GPIO Driver, (C) 2004,2005 TomTom BV
gpio_hw_init: UART 'ttySAC3' => 3
TomTom GO Accelerometer Driver, (C) 2004,2005 TomTom BV
TomTom GO Battery Driver, (C) 2004,2005,2006,2007 TomTom BV
TomTom GO GPS Driver, (C) 2004,2005 TomTom BV
TomTom GO Touchscreen Input Driver, (C) 2007 TomTom BV
Done
CoolSound engine, (C) 2004,2005 TomTom BV
CoolSound: sound_dma_init: Buffers allocated and associated.
reallocating sound DMA buffer (previous:0 new:4096 allocating:65536)
reallocating sound DMA buffer (previous:0 new:4096 allocating:65536)
iis2410: iis_init: Current clock rate: 72000000
TomTom GO Buzzer Driver, (C) 2006 TomTom BV
TomTom GO Gyro Driver, (C) 2007 TomTom BV
TomTom GO Legacy USB mode detect, (C) 2007 TomTom BV (usbmode:)
usbmode: Probing
usbmode: Initialized
usbmode: register_usbmode_driver
TomTom S3C24XX USB mode driver, (C) 2007 TomTom BV (s3c24xx_usbmode:)
TomTom GO Buspower monitor, (C) 2007 TomTom BV (buspower:)
buspower: buspower_probe
Done
Valencia/Murcia dock driver - v1.0
Cagliari dock driver - v1.0
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
s3c2443-uart.0: s3c2410_serial0 at MMIO 0x50000000 (irq = 70) is a S3C2443
s3c2443-uart.1: s3c2410_serial1 at MMIO 0x50004000 (irq = 73) is a S3C2443
s3c2443-uart.2: s3c2410_serial2 at MMIO 0x50008000 (irq = 76) is a S3C2443
io scheduler noop registeredal3 at MMIO 0x5000c000 (irq = 94) is a S3C2443
io scheduler deadline registered
RAMDISK driver initialized: 16 RAM disks of 7168K size 1024 blocksize
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
PPP BSD Compression module registered
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
TomTom GO IDE Driver, (C) 2004,2005 TomTom BV
physmap flash device: 80000 at 0
Found: EON EN29LV400BB
number of JEDEC chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
s3c2410-ohci s3c2410-ohci: S3C24XX OHCI
s3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1
s3c2410-ohci s3c2410-ohci: irq 42, io mem 0x49000000
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
usbcore: registered new driver hiddev
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.01:USB HID core driver
usbcore: registered new driver usbserial
drivers/usb/serial/usb-serial.c: USB Serial Driver core v2.0
drivers/usb/serial/usb-serial.c: USB Serial support registered for CP2101
usbcore: registered new driver CP2101
drivers/usb/serial/cp2101.c: Silicon Labs CP2101/CP2102 RS232 serial adaptor driver v0.04
s3c2443-i2c s3c2443-i2c: slave address 0x08
s3c2443-i2c s3c2443-i2c: bus frequency set to 128 KHz
s3c2443-i2c s3c2443-i2c: i2c-0: S3C I2C adapter
Bluetooth: HCI USB driver ver 2.8
usbcore: registered new driver hci_usb
Bluetooth: HCI UART driver ver 2.1
Bluetooth: HCI H4 protocol initialized
Bluetooth: HCI BCSP protocol initialized
s3c-sdi: probe: mapped sdi_base=f1200000 irq=37 irq_cd=17 dma=0.
s3c-sdi: initialization done.
s3c_hsmmc_probe: mmc1: irq = 36, base = f1400000
s3c_hsmmc_probe: initialization done.
S3C2410 GPIO SPI Driver
registering c02234dc: scp1000-baro
TomTom GO SCP1000 Barometer Driver, (C) 2007 TomTom BV
mmcblk0: mmc0:8fe4 SD02G 1931264KiB
 mmcblk0: p1
scp1000-baro: Error! Chip revision does not match!
scp1000-baro: Error initializing barometer!
registering c0223508: kxr94-gadc
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
Bluetooth: L2CAP ver 2.7
Bluetooth: L2CAP socket layer initialized
Bluetooth: SCO (Voice Link) ver 0.4
Bluetooth: SCO socket layer initialized
Bluetooth: RFCOMM ver 1.5
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM TTY layer initialized
Bluetooth: HIDP (Human Interface Emulation) ver 1.1
usbmode: usbmode_late_init
s3c24xx_usbmode: helper_disable_host_port
s3c24xx_usbmode: s3c24xx_initial_to_idle
s3c24xx_usbmode: idle_enter SUCCESS
Freeing init memory: 92K
Warning: unable to open /dev/console as initial console, res=-19.
s3c24xx_usbmode: buspower_changed POWER EVENT
s3c24xx_usbmode: s3c24xx_idle_to_device_detect
POWERSAVE: s3c2443_usb_phy_enable()
s3c24xx_usbmode: device_detect_enter
POWERSAVE: s3c2443_usb_phy_enable()
POWERSAVE: s3c2443_usb_phy_enable() was already on, resetting
s3c24xx_usbmode: s3c24xx_idle_to_device_detect SUCCESS
usbmode:[1,0,2] USB_STATE_IDLE ==( USB_EVENT_POWER_ON )==> USB_STATE_DEVICE_DETECT
usbmode: Device reset  while in device detect. switching to usb device mode
s3c24xx_usbmode: s3c24xx_device_detect_to_device
s3c24xx_usbmode: device_detect_exit
s3c24xx_usbmode: s3c24xx_device_detect_to_device SUCCESS
usbmode:[2,2,3] USB_STATE_DEVICE_DETECT ==( USB_EVENT_DEVICE_RESET )==> USB_STATE_DEVICE
s3c_hsmmc_irq: cmd timeout
s3c_hsmmc_irq: cmd timeout
s3c_hsmmc_irq: cmd timeout
s3c_hsmmc_irq: cmd timeout
s3c_hsmmc_irq: cmd timeout
s3c_hsmmc_irq: cmd timeout
selected clock c022f084 (pclk) quot 428, calc 9600
selected clock c022f084 (pclk) quot 858, calc 4800
mmcblk1: mmc1:0001 AKG00M 2007040KiB
 mmcblk1: unknown partition table
selected clock c022f084 (pclk) quot 70, calc 57591
FAT: free clusters recounted: 26503
FAT: filesystem 32 bits
FAT: free clusters recounted: 366456
FAT: filesystem 32 bits
selected clock c022f084 (pclk) quot 70, calc 57591
selected clock c022f084 (pclk) quot 428, calc 9600
selected clock c022f084 (pclk) quot 3, calc 916666
selected clock c022f084 (pclk) quot 3, calc 916666
selected clock c022f084 (pclk) quot 3, calc 916666
selected clock c022f084 (pclk) quot 34, calc 115183
selected clock c022f084 (pclk) quot 3, calc 916666
selected clock c022f084 (pclk) quot 3, calc 916666
bcsp_recv: Out-of-order packet arrived, got 1 expected 0
Personal tools